Product Information

Low viscosity C-Silicone. Ideal for two-stage technique, single-stage technique with two viscosities.

Orange flavour

Flowable consistency

Dosage:

Extrude the required quantity, observing the dosage scale on the mixing block.

Then dose a quantity of Zhermack Indurent Gel equal to the length of the fluid.

When using Zhermack Indurent Liquid, dose one drop of hardening liquid for each notch of fluid.

Mixing:

Mix energetically with the spatula, and then carefully spread the mixture out, pressing it over the mixing block to eliminate any air which may have been incorporated into the mixture.

Repeat this operation until the mix is even in colour.

Mixing time should ideally be about 30 sec.

Apply the mixture to the impression tray with a spatula or a syringe for elastomers. Working time c-silicones including mixing time is about 1 min. 30 sec.

Put into the oral cavity and wait for the mix to harden, which will take about 3 min. 30 sec.

Oranwash L - 140ml

Ref: F640

Product Information

Low viscosity C-Silicone. Ideal for two-stage technique, single-stage technique with two viscosities.

Orange flavour
Flowable consistency

Dosage:

Extrude the required quantity, observing the dosage scale on the mixing block.
Then dose a quantity of Zhermack Indurent Gel equal to the length of the fluid.
When using Zhermack Indurent Liquid, dose one drop of hardening liquid for each notch of fluid.

Mixing:

Mix energetically with the spatula, and then carefully spread the mixture out, pressing it over the mixing block to eliminate any air which may have been incorporated into the mixture.
Repeat this operation until the mix is even in colour.
Mixing time should ideally be about 30 sec.
Apply the mixture to the impression tray with a spatula or a syringe for elastomers. Working time c-silicones including mixing time is about 1 min. 30 sec.
Put into the oral cavity and wait for the mix to harden, which will take about 3 min. 30 sec.